Compound single dewatering deck ...
45 degree 2’ down-sloped back section …
The down slope is the initial drainage section for the incoming slurry.
Leading UHMW wear liner above the urethane media.
5 degree 8’ up-sloped main deck section ...
The transition pool forms at the transition from the down to up-sloped sections.
The main deck section slopes uphill to retard the material and form the filter cake as it moves along the screen.
Adjustable discharge weir at the discharge end helps tune the cake depth.
Urethane media …
.3mm x slotted steel reinforced urethane snap in panels.
Urethane interlocking lower side rail edge liners.
Full length UHMW upper side liners to protect the structural side plates of the screen.
Spindle mounted 120mm spherical roller bearings are oil splash lubricated.
Rigid shaft tubes support the bearing spindles and eccentric weights.
Outboard eccentric wheel cases allow for easy media / deck access.
Two stage input shaft seal keeps dirt out and oil in.
Linear stroke with adjustable amplitude.
Eccentric wheels have bolt-on laminates to easily adjust the stroke length.
Easy gear timing can vary the stroke angle.
Timing gears are enclosed in the bearing case and are splash oil lubricated.
Four corner H.D. spiral coil support springs.
Huckbolted laminated plate construction on the vibrating basket.
Pivoted, spring linked and tensioned motor mount.
Standard 15hp 1800 rpm tefc electric motor.
Drive sheave mounted to the input shaft with guarded v-belt drive.
Lower spring cup pads (4).
Comes complete with stand motor and drive.